Thank you. You are right, I found that
only the administration has the permission J
Kind regards,
Information Officer
Kronprinsessegade 30-32
1306 Copenhagen K.
Denmark
Tel.: +45 33 73 49 49
Fax: +45 33 73 49 48
Fra:
Sendt: 7. marts 2011 13:08
Til: [log in to unmask]
Emne: Re: Problems with Run
Reports in TMS 2010
It sounds like
either the report folder is missing or you don’t have access rights to
the report folder.
Under the
maintenance menu, select reports and check that the file paths in the
“file path” column are pointing to the folder that contains the
reports.
If that is correct,
then I would say that the security needs to be adjusted to give you read access
to the folder.
If this problem
occurs with every report selected, then it has to be one of the above.
Good luck….,
David Parsell
From:
Sent: Monday, March 07, 2011 5:48
AM
To: [log in to unmask]
Subject: Problems with Run Reports
in TMS 2010
I have not used TMS very much, but I have
tried to make reports in the earlier version without problems – just with
the built-in reports. But here in TMS 2010 I get the following message every
time I try to run a built-in report: “Error in retrieving report. Report
cannot be run”. Any solutions?
Kind regards,
Information Officer
Kronprinsessegade 30-32
1306 Copenhagen K.
Denmark
Tel.: +45 33 73 49 49
Fax: +45 33 73 49 48
To unsubscribe, send an
email to [log in to unmask]
with the following commands in the body of the email:
signoff TMSUSERS
// eoj
You will receive a confirmation that your subscription
has been removed. To unsubscribe, send an email to [log in to unmask] with
the following commands in the body of the email:
signoff TMSUSERS
// eoj
You will receive a confirmation that your subscription
has been removed.
signoff TMSUSERS
// eoj
You will receive a confirmation that your subscription has been removed. To unsubscribe, send an email to [log in to unmask] with the following commands in the body of the email:
signoff TMSUSERS
// eoj
You will receive a confirmation that your subscription has been removed.