As far as I know there is no way to add status flags to an entire batch. However, the fastest way I can tell you to do it is to open all the records you need, press "Ctrl+G", click on the status flag you want and keep your mouse hovered over that spot, press "Tab+Space Bar+Tab+Space Bar+Page Down". Page Down brings you to the next record and then you can "Ctrl+G+click+Tab+Space Bar+Tab+Space Bar+Page Down" and keep going without moving the mouse again. It saves a lot of time. But being able to do it to an entire batch would be faster. On Mon, Jun 26, 2017 at 12:19 PM, Clancy, Megan M - (meganclancy) < [log in to unmask]> wrote: > Hi all, > > > We are currently undergoing a big project that will be using status flags. > Currently we tend to use flags object by object, but this project will mean > flagging whole accession groups. Is there a way to apply a status flag to > the entire object selection? > > > Thanks, > > Megan > To unsubscribe, send an email to [log in to unmask] with the > following commands in the body of the email: > > signoff TMSUSERS > > // eoj > > You will receive a confirmation that your subscription has been removed. > -- Kit Canarina William J. Clinton Library Museum Technician 501-244-2898 To unsubscribe, send an email to [log in to unmask] with the following commands in the body of the email: signoff TMSUSERS // eoj You will receive a confirmation that your subscription has been removed.